25
Indie offers a park assist mode which allows you to switch
between forward and reverse assist to park your vehicle. Follow
these steps to enter the Park mode:
Entering Park mode
1. Ensure that the vehicle is in stand still condition and in
Ready to Ride state.
2. Press the Park button. The park symbol will blink for
3 seconds.
3. Within these 3 seconds, press the Set button to engage
Park mode.
4. It will always engage reverse park assist first. In reverse park
assist mode, the buzzer will always chime.
5. Press the Reset button to switch between reverse and
forward park assist modes.
6. You can give throttle and manoeuvre the vehicle up to
3 kmph in both directions.
Parking and Vehicle Storage
Exiting Park mode
1. Press the Park button again to exit Park mode.
2. The Indie will go back to the last riding mode used before
entering Park mode.
Parking the vehicle
After stopping the vehicle, please follow the instructions below:
1. The vehicle can be parked either on the centre-stand*
(if equipped) or side-stand.
2. Turn the handlebar to the left side, push and rotate the key to
LOCK position to lock the steering.
WARNING
• Do not park the vehicle on an incline.
• Do not lean the vehicle against a wall.
• Do not park the vehicle on a metal floor.
• Do not park the vehicle in standing water.
NOTICE
• The vehicle can be locked only if the handlebar is turned
to the left side.
River Indie User Manual | Riding the Indie
To Next Page
Loading...