GR2045401-RG-00/GR2045406-RG-00 8 of 27 20150831-Ver1
DO NOT insert any foreign objects into the valve outlet, damage to the back-check
could result. A damaged back-
check can cause a leak, possibly resulting in
explosions, fire, severe bodily harm, or death.
WARNING
FOR FILLING THE LP GAS CYLINDER
Allow only qualified LP gas dealers to properly fill or repair your LP cylinder.
DO NOT allow the cylinder to be filled beyond 80% capacity. Over-filled tanks can
create a dangerous condition. Over-filled tanks can build-up pressure and cause the
relief valve to expel propane gas vapors. The vapor is combustible and if it comes in
contact with a spark source or flame, an explosion caus
harm, or death could occur.
Always use a safety cap when grill is not connected to cylinder.
If you exchange a cylinder with a qualified exchange program, be sure the cylinder
has a Type 1 valve and an over-filling prevention device (OPD).
INSTALLING GAS CYLINDER
1.
Check that cylinder valve is closed by turning knob
clockwise.
2. Place cylinder into tank holder in bottom cabinet.
3. Orient cylinder such that valve opening faces front
burners and so that hose is not kinked/damaged.
4. Att
ach or detach regulator to LP cylinder only when
cylinder is rested atop the tank holder.
CONNECTION PROCEDURES
1. Make sure the tank valve is closed (turn valve clockwise till
tight).
2. Check tank valve to ensure it has proper external male threads.
3. Make sure all burner valves are OFF.
4. Inspect valve connections, port, and regulator assembly. Look
for any damage or debris. Remove any debris. Inspect hose for
damage. Never attempt to use damaged or obstructed equipment. See local LP gas
dealer for repair.
5. When connecting regulator assembly to the valve, hand tighten the quick coupling nut
clockwise to a complete stop. Do not use a wrench to tighten. Use of a wrench may
damage the quick coupling nut and result in a hazardous condition.
6. Open the tank valve fully (counterclockwise). Use a soapy water solution to check all
connections for leaks before attempting to light the grill (see below). If a leak is found,
turn the tank valve off and do not use the grill until a local LP gas dealer can make
repairs.
To disconnect LP gas cylinder:
WARNING
If the grill is not in use, the gas must be turned off at the supply cylinder(s). Storage
of the grill is permissible only if the cylinder is disconnected and removed from the
grill.
To Next Page
Loading...
