10
Remote Tuner Display
The MasterMind is capable of displaying tuner information from certain effects processors. This will allow you to tune
your guitar without going back to your rack to see the display on your processor.
For this to work, you will need bidirectional communication between the effects processor and the MasterMind.
Normally, messages are sent from the MasterMind to the effects processor, but in order to get the tuner information to
display, you also need communication from the effects processor back to the MasterMind. To get this communication,
you will need to connect a second MIDI cable from the MIDI output of your effects processor to the Remote In jack of
your Mastermind.
The tuner display automatically turns on when a tuner message is received – there is no need to change any settings or
switch modes on the MasterMind. When the tuner is active, the MasterMind display will show the current note name:
The preset and function LEDs will show how sharp or flat you are. The LEDs to the left mean the note is flat, to the right
means sharp. When the center LEDs (the 3 LED and the Function LED) are lit, the note is in tune.
As of version 1.4, the Fractal Audio Axe-Fx is the only supported processor. We will be adding support for other
processors in future releases.
To Next Page
Loading...
Need help?
General
