RK Rose+Krieger MultiControl quadro

Need help?

Do you have a question about the RK Rose+Krieger MultiControl quadro and is the answer not in the manual?

Summary

Compliance Declaration

1.1 EC Compliance Declaration

Manufacturer's declaration of compliance with EU directives.

1.2 EC Compliance Declaration

Further details on EC compliance for a specific system.

Controller Use and Operator Guidelines

4.1 Proper Use

4.2 Improper Use

Safety Guidelines and Signage

5.1 Safety Instructions

General safety guidelines for operating controllers and hand switches.

5.2 Safety Signs

Explanation of warning and command signs for safety.

Product Information and Specifications

6.2 Technical Specification

6.2.1 Duty Cycle

Information on permitted operating time for drives to avoid damage.

Working Life and Operation

7.2 Installation

General installation guidelines and lead layout.

7.2.2 Pin Assignment for RKMultiControl Duo

7.2.3 Pin Assignment for RKMultiControl Quadro

7.2.4 Pin Assignment for Plug Connections

7.3 Connecting Drives

How to connect drives to the controller.

7.3.2 Connecting Hand Switches

Instructions for connecting different types of hand switches.

7.4 Connecting Switch Strip - Functional Description

7.5 Commissioning

7.5.1 Initialisation Run Conditions

7.5.2 Performing Initialisation

Step-by-step guide for performing an initialisation run.

2-Key Hand Switch Initialisation

Performing initialisation with a 2-key hand switch.

6-Key Hand Switch Initialisation

Performing initialisation with a 6-key hand switch.

7.6 Connecting RKMultiControl Duo Controllers

How to interconnect RKMultiControl duo controllers.

7.6.2 Connecting RKMultiControl Quadro Controllers

How to interconnect RKMultiControl quadro controllers.

7.6.3 Load Resistor Activation (Quadro)

7.6.4 Controller Master;Slave Configuration

Setting up controllers with Master/Slave addresses.

7.7 Install Settings (Configuration)

7.7.1 Basic Configuration Procedure

7.8 Settings Table (Configuration)

Table detailing various controller settings and codes.

7.9 List of Appropriate Drives

7.12 Storing and Driving Up to Positions

7.12.1 Storing Positions

7.12.3 Place Position on a Hot Key

7.12.4 Drive Up to Stored Position

7.15 Error Messages and Fault Clearance

Table of error codes and their rectification procedures.