2 English
• SERVICING - The user should not attempt to service the appliance beyond that
descrive in the user operating instructions. All the servicing should be referred to
qualified service personnel
Note: If the display does not function properly or no reaction to operation of any con-
trol may due to the electrostatic discharge. Switch off and disconnect the AC cord and
remove all the batteries, then turn the power back on after a few seconds.
POWER SOURCES
AC POWER: You can power your portable stereo system by plugging the AC power
cord into the AC plug (19) at the back of the unit and into a wall AC power outlet.
Check that the rated voltage of your appliance matches your local voltage.
Make sure that the AC power cord is fully inserted into the appliance.
BATTERY POWER: To use the radio with batteries, disconnect the AC power cord
and insert 4 × “LR14” batteries into the compartment (20).
Be sure that the batteries are inserted correctly to avoid damage to the appliance.
Remove the batteries when the radio will not be used for a long period of time, as this
will cause leakage to the batteries and subsequently damage to your radio.
TO USE THE RADIO
Press the [FUNCTION] button (2) to power on the unit;
Select the desired audio source pressing [FUNCTION] button (2) (DAB/FM/USB/AUX
IN/CD);
(Please see detailed instructions for each Source in the following chapters);
Adjust the volume with the [VOLUME -/+] buttons (7/8) to the desired level;
Press & hold the [FUNCTION] button (2) to turn OFF the unit.
DAB RADIO OPERATION
Select “DAB” mode by pressing the [FUNCTION] button (2);
(The first time you select this function, the radio will scan the DAB radio stations auto-
matically. It will display and play the first station after the scan is done);
In case the display shows “No DAB Service”, press & hold the [PLAY] button (3) to
start automatic scan;
To select the desired radio station press repeatedly the [TUNE -/+] buttons (5/6).
PRESET
You can program a maximum of 30 preset radio stations.
Select your favourite station as explained before;
Press and hold [MENU] button (4). Select with [TUNE -/+] buttons (5/6) “Preset Sto-
re”;
Press [PLAY] button (3) to confirm;
Press [TUNE -/+] (5/6) to select the preset number;
Press [PLAY] (3) to confirm.
To Next Page
Loading...