Roadstar CLR-2466 - Alarm and Listening Functions; Wake to Buzzer Alarm; Wake to Radio; Snooze Function

English English
LISTENING TO THE RADIO
1. Set the FUNCTION Selector (71) to the ON position.
2. Set the BAND Selector (11) to the desired band (FM or MW).
3. Turn the TUNING Knob (12) until the desired station is heard.
4. Adjust the VOLUME Control (2) to a comfortable listening level.
5. To turn off the radio, set the Function Selector (1) to the OFF
position.
Note: The MW band uses a built in directional serial. You may have
to rotate the clock radio for the best reception.
SNOOZE FUNCTION
When the alarm sounds, pressing the SNOOZE Button will temporary
stop about 9 minutes then the alarm sounds again.
SLEEP FUNCTION
1. This function enables you to go to sleep listening to the Radio.
2. Set the FUNCTION Selector (1) to OFF or AUTO/BUZZER.
3. Press the SLEEP Button (6). The clock display will show 59 minutes.
The Radio turns on and will turn off automatically after 59 minutes.
4. To select a shorter time press the MINUTE Button (8) while holding
the SLEEP Button (6) until the desired sloop time is displayed.
5. To turn off the Radio at any time during the Sleep period, press
the SNOOZE Button (10).
WAKE TO BUZZER ALARM
1. Set the alarm time as shown above.
2. Set the Function Selector (1) to the AUTO position.
3. Turn the VOLUME Control (2) down until you hear a click.
4. To switch off the alarm either press the ALARM SET/OFF Button
(5), or set the FUNCTION Selector (2) to the OFF position.
WAKE TO THE RADIO
1. Set the alarm time as shown above.
2. Set the FUNCTION Selector (1) to the ON position.
3. Set the Band Selector (11) to the desired radio band, and follow
the procedure in LISTENING TO THE RADIO to tune the radio to
a station.
4. Set the VOLUME Control (2) to a level you feel will wake you.
5. Set the FUNCTION Selector (1) to the AUTO/BUZZER position.
6. To switch off the alarm either press the ALARM SET/OFF Button
(5) or set the FUNCTION Selector (1) to the OFF position.
56