Before first use
1.Remove all the packing material.
2.Remove any stickers or labels from the device 一 other than the rating label.
3.Thoroughly clean the basket, and frying tray, with hot water and some liquid
washing soap using a non-abrasive sponge.
4.Wipe the inside and outside of the device with a moist cloth.
How to use the device?
1. Power on
Plug in, there is BEEPS sounds. Light up. 1 seconds will be back to standby mode: all
light will be off expect (•).
2. Menu selection/Temperature/Time
Plug in, it is at the standby mode, press (•) , default temperature and default time of the
Program are 180°C, 15 min respectively, at that time you can adjust the time and
temperature freely by using Time +/- and Temperature +/- button. You can also press
any function icon to cook different food. When press the function icon, the lights
flickered, then press Ml unit start to work. Every function have its own default time
and temperature (As shown in the table). Customer can adjust the time and temperature
freely by using Time +/- and Temperature +/- button.
(1) . The temperature control range is 50-200°C, every click on the + / - temperature
will increase or reduce 10°C. At 200°C, press the will loop back to a temperature of
50°C, press the at 50°C temperature will cycle back to 200°C. In the process of
temperature control, temperature digital display will flicker on the screen (not flashing
during working), after flickering 3 times, the temperature has been done of setting.
(2) . The adjusting time range is 1 to 60 mins, every click on the + / - time will
increase or reduce 1 min. At 60 min if you press the time will cycle back to 1 min. At 1
min , if you press the temperature will cycle back to 60 min. In the process of time
control, time digital display will flicker on the screen (not flashing during working),
after flickering 3 times, the time has been done of setting.
3. Start, Pause/Stop
After choose function ,set the appropriate time and temperature, press HI , the Ml start
to flicker, after BEEPS sounds, device start to work. During the device working, press
Ml, after BEEPS sounds, device stop working, Ml stop flickering, during the device
working, press (•) , after BEEPS, device stop working, and then the device back to
standby mode.
To Next Page
Loading...