2013 Robalo R180 & R200 Owner’s Manual
Robalo Boats, LLC
Nashville, GA
robalo.com
9-3
• Cover battery terminals with rubber or plastic caps to prevent accidental
contact between battery posts and metal objects.
• Clean outside battery case, terminals, and battery clamps with a baking
soda and water solution. Do not allow solution to enter battery cells.
• Clean battery posts and clamps with fi ne grit emery cloth. Use a light
sanding motion when cleaning.
• Apply a light coat of petroleum jelly to cover end of battery cables.
• Recharge battery monthly or trickle charge continuously while battery
is stored.
RECOMMISSIONING
NOTE: For detailed information on recommissioning your boat’s
systems and equipment, refer to the owner’s manual for each sys-
tem or component.
1. Inspect, visually and by smelling, the fuel system and all associated
components for proper connections, wear, leaks, or other damage and
needed repair.
Important: Inspection of the fuel system at recommissioning is very
important. We cannot overemphasize our concern for your safety.
2. Clean battery terminal posts with wire brush or steel wool before rein-
stallation.
3. Check charge on battery. Recharge or replace if necessary.
4. Inspect all battery wiring. Repair or replace if necessary.
5. Attach battery cables, and tighten cable clamps.
6. Apply petroleum jelly or marine grade grease on battery posts and
clamps to eliminate air pockets and possible acid buildups.
7. Reinstall hull drain plug after coating threads with petroleum jelly.
8. Clean bilge area.
9. Inspect all wiring for fraying, wear, loose connections, or other damage.
Repair or replace if necessary.
10. Test operation of navigation lights and other lighting onboard. Inspect
all switches, controls, and other related equipment for proper operation.
Repair or replace as necessary.
11. Inspect all life jackets, anchor lines, and other safety equipment for
proper operation and physical condition. Repair or replace if necessary.
https://www.boat-manuals.com/
To Next Page
