To Next PageTo Next Page
Need help?Do you have a question about the robatherm RMC Series and is the answer not in the manual?
General| Brand | robatherm |
|---|---|
| Model | RMC Series |
| Category | Air Handlers |
| Language | English |
General information, intended use, and safety for air handling units.
Measures to prevent fire spread between AHU sections.
Preventing freezing of dampers or unit failures during cold periods.
Critical safety warnings, regulations, and ATEX unit requirements.
Procedures for fire situations and general caution.
Guidelines for periodic maintenance and cleaning of the unit casing.
Recommended disinfectants and steps after maintenance for ATEX units.
Testing leakage and guidelines for spare parts, service, and repair.
Procedures for goods inspection, unloading, and transport of units.
Using lifting eyes, transport loops, or fork lift trucks for unit unloading.
Unit installation, foundation requirements, standing safety, and lifting gear.
Sound reduction, insulation, and methods for connecting unit sections.
Sealing unit section joints and weatherproof unit openings.
Connecting air ducts, flexible connections, and decoupled frames.
Safety measures for equipotential bonding and lightning protection.
Connecting heating and cooling water piping correctly.
Proper connection of condensate piping with siphons and trap calculation.
Requirements and safety for electrical connections and motor protection.
Specific requirements for motors in explosive atmospheres (ATEX).
Final inspection, cleaning, and alignment of access doors.
Instructions for installing and assembling rotary heat exchangers.
Steps and materials for sealing the roof of weatherproof units.
Commissioning, safety, and periodic maintenance for dampers.
Procedures for commissioning fans and motors, including safety.
Periodic and necessary maintenance for fans.
Periodic and necessary maintenance for electric motors.
Periodic and necessary maintenance for belt drives.
Periodic and necessary maintenance for drive clutches.
Determining V-belt tension and safe motor removal procedures.
Measuring and adjusting V-belt tension and deflection.
Commissioning, monitoring, and resistance values for air filters.
Maintenance intervals, precautions, and replacement procedures for filters.
Commissioning, inspection, and maintenance of silencers.
Commissioning, safety, and charging procedures for heating coils.
Maintenance intervals, safety, and cleaning methods for heating coils.
Step-by-step instructions for coil disassembly and reassembly.
Commissioning, safety, and operational checks for electric heaters.
Maintenance intervals and safety precautions for electric heaters.
Commissioning, safety, and charging procedures for cooling coils.
Maintenance intervals and procedures for cooling coils and drop eliminators.
Procedures for shutting down heat exchangers for extended periods.
Commissioning, safety, and requirements for refrigeration units.
Commissioning, inspection, and sealing for rotary heat exchangers.
Maintenance intervals and precautions for rotary heat exchangers.
Commissioning, inspection, and maintenance of plate heat exchangers.
Commissioning, inspection, and maintenance of heat pipes.
Commissioning, rotor speed, and pressure drop for desiccant rotors.
Maintenance intervals and procedures for desiccant rotors.
Commissioning, safety, and connections for combustion chambers.
Putting the burner into operation, checking parameters, and safety controls.
Commissioning, regulations, and connections for gas surface burners.
Water quality checks and limits for spray humidifiers.
Commissioning, fresh water, and connections for high-pressure spray humidifiers.
Commissioning and setting pressure relief dampers.
Commissioning, requirements, and work for controlling systems.
Commissioning, inspections, and charging for hydraulic sets.
Instructions for shutting down the system for longer periods.
Procedures and safety regulations for unit disassembly and disposal.
