Need help?Do you have a question about the robatherm RM and is the answer not in the manual?
Details the purpose and scope of the manual's instructions.
Mentions that instructions cover all available options and may vary by country.
Identifies hazards like injury from modifications, falling objects, and overload.
Lists required qualifications for personnel working on the AHU.
Provides emergency procedures for fire and leaks.
Outlines cleanliness, ventilation, and environmental conditions for the installation site.
Specifies space requirements for AHU installation and maintenance access.
Covers foundation stability, leveling, and securing the AHU.
Describes methods for supporting the AHU on beams, including deflection limits.
Instructions for using lifting jacks and handling unit components.
Procedures for connecting casing sections and ductwork.
Methods for securing AHUs to on-site beams using clamps.
Steps for connecting AHUs using a roof rack frame system.
Proper installation of condensate, drain, and overflow lines with siphons.
Procedures for sealing separation points and corners on weatherproof units.
Steps for fitting and securing protection roofs onto AHUs.
General steps for installing filters, avoiding damage.
Specific procedures for HEPA filters per EN 1822 standard.
Guidance on checking filter contamination and recommended pressure loss.
Notes on transport locks and their removal to prevent damper damage.
Checking and installing plug fans, including gap measurements.
Assembly, sealing, bearing, and drive instructions for rotary heat exchangers.
Guidelines for connecting run-around coils in a counterflow principle.
Frost protection for heating/cooling coils and operational notes for steam heaters.
Fire hazard warnings and installation of safety limiters for electric heaters.
Safety warnings and checks for moving parts and connections.
Adjusting release/contact pressure via weights and dimension 'a'.
Hazards from infection/hypersensitivity due to poor water quality in humidifiers.
Specifies water quality limits for circulating spray humidifiers.
Key requirements for electro steam humidifiers, including tubing.
Hazards of refrigerant leaks, flammable substances, and explosion risks.
Safety warnings and procedures for connecting refrigerant lines.
Checks for proper installation and guidelines for system flushing.
Procedures for filling hydraulic sets and removing air pockets.
Requirements for combustion chambers, burners, and connections.
Assembly, connection, and tightness checks for direct gas-fired heaters.
Proper installation of control system devices, including duct smoke detectors.
Risks from mercury in UV-C illuminants and handling precautions.
Steps for cleaning components and removing metal chips before startup.
General| Brand | robatherm |
|---|---|
| Model | RM |
| Category | Air Handlers |
| Language | English |
To Next Page