Direct firing
82 © robatherm
Direct firing
Combustion chamber
Observe requirements according to DIN 4794, DIN 4755, and DVGW worksheet G600.
Connections
In the case of on-site burners, approval must be requested from robatherm for the purpose of
checking compatibility with the selected combustion chamber.
Assembly of the oil or gas burner according to the manufacturer's instructions.
Connect the burner to the gas or oil line. Make sure that the connection is deenergized. The operating
instructions of the burner manufacturer must be strictly observed. Gas type and gas pressure must be
suitable for the control line.
The prerequisite for achieving the nominal heat output is compliance with the gas-side supply
pressure (see data sheet). The nominal heat output may not be achieved if the supply pressure falls
below the specified value under operating conditions.
Assembly and wire all sensors (e.g., room thermostats).
Each installation must be equipped with an emergency switch.
Chimney
Make connection to the chimney in accordance with the applicable regulations. The exhaust system
must comply with local building and official regulations.
Condensate combustion chamber
Follow the instructions of the respective combustion chamber supplier. These are part of the supplied
documentation. With oil, condensation should be avoided. The condensate connection must be made
in such a way that any condensate produced is drained off in accordance with local regulations.
To Next Page
Loading...