Directory
© robatherm 87
Directory
List of figures
Fig. 1: Parts of the instructions 6
Fig. 2: AHU footprint requirements 13
Fig. 3: Footprint requirements of HE-RAC hydraulics on stand 14
Fig. 4: Maximum incline 16
Fig. 5: Maximum inclination angle 16
Fig. 6: Compensating unevenness 16
Fig. 7: Deflection of the AHU 17
Fig. 8: Longitudinal support 17
Fig. 9: Longitudinal support for units on DIN frames 17
Fig. 10: Width support 18
Fig. 11: Width support for units on DIN frames (identification) 18
Fig. 12: Width support for units on DIN frames (dimensions) 18
Fig. 13: Foundation spots 19
Fig. 14: Foundation spot for units on DIN frame (designations) 19
Fig. 15: Foundation spot for units on DIN frame (dimensions) 19
Fig. 16: Unit foot 20
Fig. 20: Lifting jack 21
Fig. 21: Longitudinal support 21
Fig. 22: Width support 22
Fig. 23: Foundation spots 22
Fig. 24: Housing connection with through bolt and nut 23
Fig. 25: Casing connection with rivet nut 23
Fig. 26: Mounting with beam clamp F9 (A) 25
Fig. 27: Fastening with DIN 434 wedge washer (E) 25
Fig. 28: Fastening with beam clamp FC (F) 25
Fig. 29: Lower AHU set up 27
Fig. 30: Crane upper section individually 27
Fig. 31: Setting down the upper section 27
Fig. 32: Disassembling roof rack brackets 27
Fig. 33: Turning roof rack brackets 28
Fig. 34: Roof rack bracket assembly 28
Fig. 35: Connection of upper and lower AHU 28
Fig. 36: Flexible connection 29
Fig. 37: Unit connection frame 30
Fig. 38: A - supporting rod; B - cross rod 31
To Next Page
Loading...