Filter component
© robatherm 55
Filter component
Filter installation
1. Hand-tighten the filter in the mounting frame with filter clamps or a bayonet lock.
2. Do not pinch or damage the filter.
3. Check the air-tight fit of the filters in the mounting frame.
HEPA filter installation according to EN 1822
HEPA filter installation according to EN 1822
The preassembled filter component for HEPA filters according to EN 1822 consists of the following
components:
Fig. 103: F - rivet nut M8, hexagonal, V2A; G - filter wall
To Next Page
Loading...