ENGLISH
16
Instructions and User Manual
WINGS
03
ARF
Now mount the servo arms in 90 ° position on the previously neutral servo. Drill a hole in the aileron servo
arm at a distance of approx. 9mm from the output to 1.6mm. For ap servo arm select a bore distance of
approx. 6mm. The servo arm is screwed on one tooth forward (towards the leading edge).
04
ARF
Now make two 43mm long linkages for the ailerons from
the M2 clevises, nuts and threaded rods. For the aps take
the linkage with Z-bend and clevis.
05
ARF
Screw the brass rudder horns with thread locking com-
pound into the threads in the rudders. Then hook the
linkage into the holes on the rudder and servo levers.
06
ARF
Now glue both aileron servos with slightly thickened
epoxy resin. The exact position is now determined by the
neutrally fastened rudder blade, the 90 ° servo lever and
the rod length.
07
ARF
The aps are cross-jointed in the classic way, i.e. from the
underside of the wing to the top. Now make two 44mm
long linkages for the aps from the short Z-booms and
M2 clevises. The gluing is done in the same way as for the
ailerons, but now the servo arm is slightly tilted forward in
the electronic neutral position.
To Next Page
Loading...
