Need help?Do you have a question about the ROBBE Valdivia and is the answer not in the manual?
Explains numbering, scrap material, part identification, and general build process.
Instructions for trimming excess material, cutting stem and keel parts, and preparing reinforcements.
Steps for assembling the stem core and fitting it into the hull, ensuring proper alignment.
Instructions for fitting the stern tube and gearbox assembly into the motor bulkhead.
Steps for installing the electric motor, capacitors, and connecting power leads.
Instructions for assembling the rudder, tiller, and connecting parts to the rudder shaft.
Steps for fitting the rudder assembly into the hull and checking alignment and clearance.
Guidance on positioning and gluing the lead ballast blocks inside the hull, noting safety precautions.
Instructions for preparing and laminating the deck girders using a special tool for camber.
Steps for cutting hatch openings and fitting the deck assembly to the hull using screws and clamps.
Detailed steps for applying the planking strips and caulking, ensuring symmetry and proper fit.
Step-by-step instructions for assembling the main winch mechanism and its parts.
Instructions for assembling the foresail winch and its components, including drum and fittings.
Steps for cutting, shaping, and fitting the bulwark components to the hull, including stanchions.
Detailed steps for assembling the cabin walls, roof planking, and hatch covers.
Steps for installing the power switch, speed controller, battery, and connecting RC components.
Instructions for attaching gaff sails to masts, including halyards and sheets.
Steps for attaching foresail, jib, and flying jib using pulley blocks, lines, and hooks.
Steps for connecting sheets to the main boom and schooner boom, and adjusting tension.
Steps for assembling and installing the anchor, chain, and anchor halyard onto the hull.
To Next Page
General