Need help?Do you have a question about the Robe Color Spot 250 AT and is the answer not in the manual?
Essential safety guidelines and warnings for operating the device safely.
Explains the device's intended use as a moving-head spot for decorative effects indoors.
Step-by-step instructions for safely installing and adjusting the lamp.
Guidance on inserting and replacing gobos and color filters in the fixture.
Procedure for replacing the 3-facet prism in the fixture.
Instructions for installing optional 12° or 18° lenses.
Procedures for securely mounting the fixture using clamps and safety ropes.
Details on connecting the fixture to the mains power and setting voltage/frequency.
How to connect fixtures using DMX-512 for control and create chains.
Assigning DMX addresses and controlling fixture functions remotely.
Details on functions like lamp, color wheel, and gobo wheel controllable via DMX.
Setting DMX addresses and configuring master/slave operation modes.
Accessing operational data like lamp hours, strikes, and internal temperatures.
Modifying fixture behavior and operational parameters through personality settings.
Manual control for switching the lamp on/off and operating effects directly.
Running built-in test sequences and configuring standalone operating modes.
Editing custom programs, performing resets, and accessing special functions.
Instructions for entering a low power mode for address setting without a full reset.
Explanation of common error messages and their potential causes for troubleshooting.
Guidelines for cleaning the fixture's lens, fans, gobos, and filters regularly.
Step-by-step instructions for safely replacing the internal fuse.
General| Type | Moving Head |
|---|---|
| Color Mixing | CMY |
| Effects | Frost effect |
| Control Protocol | DMX512 |
| DMX Channels | 16 |
| Focus | Motorized focus |
To Next Page
