Press [SET] and release only when
the indicator is lit and stays on
(after about 3 sec).
The indicating light is on
Enter the 3-digit code (for
example, the code for PHILIPS is
487).
If the code is entered correctly,
the indicator light will go o. If
the code is not entered correctly
(a wrong digit has been entered),
the indicator will ash three
times and remain in setup mode
(indicator light is on). Enter the
code again. If setup is successful,
the indicator light should go o.
Indicator light is o
IMPORTANT: Write down the correct code on a sticker under the remote
control battery cover. That way you can nd it quickly and easily, when
needed.
Point the remote control at the
device and try pressing some keys
on the remote control. If some or
all of the main keys do not work,
repeat the steps in 2 to 4 and try
other codes from the table until all
of the main keys work.
- 5 -
34-500
To Next Page
Loading...
