Robert Smart R-919 - Automatic Code Search; Procedure

IMPORTANT:
- This remote control cannot increase the number of features of the TV.
For example: if your TV does not have the function (turn o sound), the
remote control key will not work.
- Some of the functions of the remote control may not work.
- The symbol and the function of the key may not match.
C. AUTOMATIC CODE SEARCH
Automatic code search is recommended if you have tried the 'QuickSet'
option and the option of entering the code from the code table
unsuccessfully. This function will look for codes from an even larger list
stored in the memory of the remote control, which enables linking the
remote control even to specic models.
Manually turn on the TV - it must
be fully turned on and not just in
standby mode!
Point the remote control at
the device, and press and hold
[SET]. After about 6 seconds,
the indicator light will begin to
ash, an automatic search will
begin and the remote control
will transmit codes to the TV.
When the volume control symbol
appears on the TV screen, release
the [SET] key - the indicator light
on the remote control should go
o.
Indicator light is o
Point the remote control at the
device and try pressing some keys
on the remote control. If some or
all of the main keys do not work,
repeat the steps in 2.
- 6 -
34-500