To Next PageTo Next Page
Need help?Do you have a question about the Roberts Gorden GordonRay BH Series and is the answer not in the manual?
General| Brand | Roberts Gorden |
|---|---|
| Model | GordonRay BH Series |
| Category | Heater |
| Language | English |
Lists all components included within the BH-Series burner carton for initial setup.
Details the specific parts included in core and extension packages for BH-Series heaters.
Outlines key performance metrics including BTU rate, length, and mounting heights.
Covers physical dimensions, pipe connections, gas inlet pressure, and electrical rating.
Specifies minimum clearances for standard, one-side, two-side, and U-tube reflectors.
Details minimum clearances for decorative grilles and lower clearance shields.
Identifies and describes the primary components of the BH-Series heater.
Illustrates the arrangement of components for a linear BH-Series heater assembly.
Guides critical hanger placement and suspension for safe heater installation.
Provides step-by-step instructions for assembling tubes, couplings, and reflectors.
Details the correct procedures for installing the burner and turbulator.
Explains the installation process for optional U-tube accessories.
Guides installation of elbow packages and reflector joint connections.
Covers the installation of decorative grilles and protective clearance shields.
Details the installation of reflector side extensions.
Describes different venting configurations including horizontal and vertical methods.
Outlines requirements for single and double heater outside air supply.
Provides instructions for connecting the gas supply using flex connectors.
Illustrates line/low voltage thermostat wiring and internal electrical connections.
Displays a visual diagram of the internal components of the burner assembly.
Details the terms, conditions, and limitations of the product warranty.
