Roberts Gorden Combat POP 030

To Next Page

FOR YOUR SAFETY

If you smell gas:

1. Open windows.

2. DO NOT try to light any appliance.

3. DO NOT use electrical switches.

4. DO NOT use any telephone in

your building.

5. Leave the building.

6. Immediately call your local gas

supplier after leaving the building.

Follow the gas suppliers

instructions.

Do not store or use petrol or other

flammable vapours and liquids in the

vicinity of this or any other appli-

ance.

Failure to follow these instructions

can result in death, injury or property

damage.

WARNING

Improper installation, adjustment, alteration,

service or maintenance can result in death, injury

or property damage. Read the Installation,

operation and service manuals thoroughly before

installing or servicing this equipment

Installation must be done by a contractor qualified

in the installation and service of gas/oil fired

heating equipment (whichever is applicable).

Installer

Please take time to read and understand these

instructions prior to any installation. Installer must

give a copyof this manual to the user/owner.

Owner/User

Keep this manual in a safe place close to the heater

to provide your serviceman with information should it

become necessary.

Roberts-Gordon Europe Ltd.

Oxford Street

Bilston, West Midlands WV14 7EG UK

Telephone: +44 (0)1902 494425

Fax: +44 (0)1902 403200

email: uksales@rg-inc.com

www.combat.co.uk

www.rg-inc.com

Combat

Warm Air Cabinet

& High-Flow Heaters

OIL FIRED: POP, POPH and

POP /H versions

Models 015 to 0100

GAS FIRED: PGP, PGPH and

PGP /H/M versions

Models 015 to PGP 0100

Installation, Commissioning,

Service & User Instructions

WARNING

Fire Hazard

X523F 02/03

Need help?

Do you have a question about the Roberts Gorden Combat POP 030 and is the answer not in the manual?

Summary

Section 2. Technical Data

2.4 Honeywell Combination Fan;Limit Thermostat

2.8 Fan Data - High Flow Cabinet Heaters

Presents performance graphs for fans in High Flow cabinet heaters.

Section 3. Installation Requirements

3.1 Required Standards

Outlines the key UK regulations and standards for heater installation.

Section 4. Installation of the Heater

4.1 Flue

Details requirements for the installation and termination of the flue system.

4.2 Electrical Supply

Specifies electrical supply requirements and earthing procedures.

4.4 Fuel Oil Supply

Covers requirements for fuel oil storage tanks, pipes, and supply systems.

4.5 Gas Supply

Details gas supply requirements, including natural gas and LPG pressures.

Section 5. Commissioning the Heater

5.1 Commissioning

Outlines pre-commissioning checks, including electrical tests.

5.2 Commissioning the Burner - OIL HEATERS

Step-by-step guide for commissioning oil-fired burners.

5.3 Commissioning the Burner - GAS HEATERS

Step-by-step guide for commissioning gas-fired burners.

Section 7. Servicing Instructions

7.1 Burner Maintenance

Details routine maintenance procedures for the burner assembly.

Section 8. Removal & Replacement of Parts

Section 9. Fault Finding Charts

9.1 Oil Burner Fault Finding

Troubleshooting chart for common issues with oil burners.

9.2 Gas Burner Fault Finding

Troubleshooting chart for common issues with gas burners.

Section 10. User Instructions

10.1 Heater Operation (On;Off Operation)