If you need any further advice, please call our Technical Helpline on :-
1300 556 816
9
Using the sound system for the fi rst time
1. Place your sound system on a fl at surface.
2. Fully extend the telescopic aerial. The aerial should be fully extended
and positioned vertically for optimum reception.
3. Plug the mains lead into the mains socket located on the back of your
sound system ensuring that the plug is pushed fully into the socket.
4. Plug the other end of the mains lead into the wall socket and switch
on the wall socket.
IMPORTANT: The mains plug is used as the means of connecting
the sound system to the mains supply. The mains socket used for the
sound system must remain accessible during normal use. In order to
disconnect the sound system from the mains completely, the mains
plug should be removed from the mains socket outlet completely.
5. When your sound system is fi rst switched on the clock display will
show 12:00 and the unit will enter standby mode. It will then scan for
DAB+ radio stations and when stations have been found the clock
and date should be set automatically. Note that the display will not
show any scanning message for this fi rst scan.
6. If no stations have been found then the clock will not set. You may need
to relocate your sound system to a position giving better reception.
You should then carry out an auto-tune to fi nd DAB+ stations. See
DAB+ Operation on page 10 and also Finding New Stations on page
13. The clock will then be set from a DAB+ broadcast.
Introduction
To Next Page
Loading...
