Roberts MP-SOUND 43 - DAB+ Radio Operation

10
Operating your sound system - DAB+
1. Fully extend the telescopic aerial. If your sound system is in standby
mode, press the On / Standby button to switch it on.
2. Press and release the Radio button to select DAB+ mode. The display
will show "DAB" for a few seconds.
3. If this is the fi rst time the sound system is used a quick scan of the
DAB+ channels may be carried out (depending on whether scanning
was already completed in standby mode). If the radio has been used
before, the last used station will be selected.
4. When fi rst switched on, the fi rst station in the list of stations will be
shown. Press and release the Select button to tune to this station or
press the Tuning Up or Down buttons to select an alternative station.
See selecting a station on the following page. The display will show
the station name on the upper line of the text display and broadcast
information on the lower line.
5. If the station list is still empty after the scan operation or if the
selected station cannot be received your radio will display "Service
not available".
6. If no signals are found it may be necessary to relocate your sound
system to a position giving better reception, and then repeat the scan
using the Auto-tune facility (see Finding New Stations on page 13).
Note that radio station name and frequency displays shown in this user
guide may differ from those that you see on your radio. Broadcasters may
change radio station names that are transmitted, and the frequencies
used for DAB+ and FM radio stations may not be the same in all parts
of the country.
1
2
DAB
DAB
DAB