5
Operating your sound system
1. Press the On / Standby button to switch on your sound system. The
display will show "TUNING" for a few seconds.
When fi rst switched on, the sound system will be in DAB mode. After
each use the sound system will remember the mode used and then
switch on in that mode the next time that it is used.
2. If the sound system has been used before, the last used station will
be selected.
3. If this is the fi rst time that the sound system has been used, then the
fi rst station in the list of stations found during scanning will be played.
The display will show the station name on the display.
4. If no signals are found then "OFF AIR" will be displayed and it may be
necessary to relocate your sound system to a position giving better
reception. You should then carry out a scan to fi nd stations as described
on page 9.
• Your sound system has an indicator
on the display to indicate
the strength of the DAB radio signal being received.
1
To Next Page
Loading...
