CAUTION
1. WARNING: If you do not follow these instrucons exactly, a re
or explosion may result with property damage, personal injury
or loss of life.
2. Smell all around the appliance area for gas. If the appliance uses
L.P. (boled) gas also be sure to smell next to the oor because
L.P. gas is heavier than air.
3. WARNING: If you smell gas, immediately shut o the manual
valve in the gas piping to the appliance. Don’t touch any
electrical switch or use the phone. Leave the building and call
your gas supplier. If he cannot be reached, call the re
department.
4. WARNING: Do not force the gas control knob on the appliance.
Use only your hand to push down and/or to turn the gas control
knob. Never use any tools. If the gas control knob will not
operate by hand, the control should be replaced by a qualied
service technician. Forced or aempted repair may result in re
or explosion.
5. WARNING: The gas control must be replaced if it has been
exposed to water.
INSTALLATION INSTRUCTIONS (CON’T)
OPERATING INSTRUCTIONS
1. Turn wall thermostat to its lowest seng. Remove burner access
panel(s).
Selector arm must only be operated by hand (see below). DO NOT
use pliers, wrenches or other tools to operate the arm. The selector
arm cannot be moved into the “o” posion without rst
depressing the lever to the “on” posion.
2. Move selector arm to the “o” posion. (See gure 1.)
3. WARNING: Wait at least 5 minutes to allow any gas in the
combuson chamber to vent. If you then smell gas in the appliance
area or near the oor, STOP and follow warning instrucons to the
le. Failure to do so may result in re or explosion.
4. Move selector arm to the “on”’ posion, (see gure 2), and set
room thermostat to desired temperature. Allow burner to cycle on
and o.
5. Leak test with a soap soluon aer installing with main burner on.
Coat pipe and tubing joints, gasket, etc. with soap soluon. Bubbles
indicate leaks.
6. Replace burner access panel.
Figure 1 Figure 2
To Next Page
Loading...
Need help?
General