To Next PageTo Next Page
Need help?Do you have a question about the Robertshaw 9801i2 and is the answer not in the manual?
General| Temperature Range | 45°F to 90°F (7°C to 32°C) |
|---|---|
| Display | Digital |
| Stages | 1 Heat/1 Cool |
| Hold Feature | Yes |
| Backlight | No |
| Battery Life | Up to 1 year |
| Power Source | Battery (2 x AA) |
Override temperature setpoint for up to 24 hours.
Override temperature setpoint for up to one year.
Preprogrammed setpoints for energy savings.
Navigate programming menus and events.
Configure automatic DST adjustments.
Select humidification modes (Off, With Heating, Independent).
Set desired humidity and dew point adjustments.
Select dehumidification modes (Off, With Cooling, Independent).
Set preferred humidity levels for dehumidification.
Configure stage activation degrees and delays.
Select thermostat or remote sensors.
Define range for heating/cooling switching.
Feature for proactive setpoint achievement.
Units (°F/°C), resolution, and offset.
Choose display language (English, French, Spanish).
Set reminders for filter, bulb, humidifier pad.
Adjust screen backlight and clarity.
Configure heating/cooling stages and types.
Define stage interaction and fan operation.
Prevent compressor damage from short cycles.
Optimize heat pump efficiency based on outdoor temp.
Configure maintenance alerts for system components.
Set maximum allowable temperatures.
Automatically switch between heating and cooling.
Restore factory settings for all parameters.
Protect system settings with a PIN.
Control access to thermostat functions.
Explanation of balance points for heat pump operation.
Indicates time/date setup is required.
Range for heating/cooling switching control.
Feature for proactive setpoint achievement.
Warning against changing installer-configured settings.
Options for 2, 4, or 6 daily program events.
Benefits and use of remote sensors.
Guidelines for installing outdoor sensors.
Customizing temperature by time and location.
Thermostat's response to sensor failure.
Procedure to reset thermostat to factory defaults.
How to tell if heating or cooling is active.
