USING THE ALARM and/or HOURLY CHIME
The alarm can be armed (set to go off) to sound once per day. The alarm symbol (((o))) will appear when
the alarm is armed.
The hourly chime can be armed (set to go off) to sound one (1) beep every hour on the hour. The chime
indicator (♠) will appear when the hourly chime is armed.
ARMING AND DISARMING THE ALARM AND HOURLY CHIME
With your watch in NORMAL TIME (no digits appear flashing):
(1) Pr
ess (C) and the alarm symbol (((o))) appears (alarm is armed to sound at the time set (i.e. 7:30 A)).
(2) Press (C) again and the alarm symbol disappears and the Chime symbol (♠) appears.
(3) Press (C) again and both the alarm and chime symbols appear.
(4) Press (C) again and both symbols disappear (alarm & chime are disarmed).
When armed, the alarm will sound when the alarm time coincides with the time of day. You may silence
the alarm by pressing any pushbutton.
PART III. CHRONOGRAPH (STOPWATCH) AND SPEED TIMER SET-UP
The SC-888 offers a variety of timing options for both the Chronograph and Speed Timer modes. Please
take a moment to become familiar with these options, before setting and using these functions.
Memory Recall Direction: You may review up to the 150 previous readings in either Up (ascending -
1,2,3, . . . 149, 150) or Down (descending – 150, 149 . . . 3,2,1) order. UP (⇑) or Down (⇓) indicators
appear on the far left above the upper row of digits.
To select UP or DOWN, press (F) in the RESET (all zeros) position. Once selected, memory direction
cannot be changed while the timer is running or not reset.
LAP or SPLIT timing: (Chronograph mode only)
You may select to display LAP or SPLIT times. Lap (“LAP” )an
d Split (“SPL”) indicators appear below
the bottom row of digits.
“LAP” Chrono will display the Interval
of time from your previous readings. Each time a reading is taken,
the chronograph begins from zero.
“SPLIT” Chrono will display the Accumulation
of time from the start of the event. Each time a reading is
taken, the chronograph shows the Total
amount of time accrued.
Single, Double or Triple Timers. The SC-888 will accommodate up to three (3) separate timers. In the
Chronograph and Speed Timer set-up modes, you may select from Single “1”, Double “2”, or Triple “3”
options. Single, Double or Triple refers to the SC-888’s ability to time one, two or three activities or
participants at once.
Lap Counter(s)
There is an automatic Lap Counter associated with each timer in use. A Lap Counter displays the number
of readings taken.
To Next Page
Loading...
