ROBINHOOD RHCD7W - Operation Instructions - Programs; Program Selection Process

10
Operation Instructions
Program selector
1. Press the【On/Off 】 button ,when the LED display screen brightens up, rotate the program knob to
select the desired program.
2. Select the【Delay】,【Time】,【Intensity】,【Speed Dry】,【Signal】or
【 Anti-Crease 】 functions for additional option.
3. Press the【Start/Pause】button.
Program start
The drum will keep rotating after the program starts, the state light in the display area will flash in
sequence, the remaining time displayed will change automatically.
Program end
1. The drum will stop running after the program ends, the buzzer will beep, the display will show
" ", the last cycle phase status light will flash. The dryer will start 【Anti-crease】function if
user doesn’t remove the load in 1 minute. Please press【On/Off】key to cut off power and pull
the plug out.
2. Deal with the problem according to “Malfunction display and solutions”, if there is a unexpected
stop during the drying procedure and the dryer show information.
Other Functions
• Instructions of the 【Delay】 function
This function is used for delaying clothes drying time within 24 hours. The delay time means the program
will start after x hours. When the delay program starts, the time starts to decrease on the display and the
delay icon blinks.
Steps in details
1. Load your laundry and make sure the machine door is closed.
2. Press the 【 On/Off 】 button, then to turn the program selector knob and select a desired program.
3. You can select the 【Anti-Crease】 or 【Signal】functions according to your need.
4. To press the 【Delay】 key.
5. Continue to press the 【Delay】to select the delay time.
6. After the 【 Start/Pause 】 button is pushed, the dryer is at the run condition. The drying procedure will be
automatically performed when the delay time is over.
7. If you push the 【 Start/Pause 】 button again, the delay function will be paused.
8. If you want to cancel the “Delay” function, please press the 【 On/Off 】 button.