D 630 V1112 53
NederlandsFrançaisEnglishDeutsch
Problems and troubleshooting
1 The machine does not start when the start button is activated:
- workshop main fuse is switched off: power cut, power shortage, or general overload.
- main switch off: put switch on “1”.
2 Reduction of cutting speed when working:
- belt tension not correct: tension the belt
- motor overload due to incorrect feed rate: reduce the feed rate
- blunt tools: sharpen tools
3 Vibration of the machine:
- worn or damaged belt: replace the belt
- overtensionned belt: loosen belt
4 Thermal overload does not re-arm automatically after shut-off and cooling down period:
- overload is not set on automatic reset, or the overload is faulty: set on automatic, or replace
If you cannot solve the problem yourself or you do not find your problem in this list,
please contact your Robland dealer.
To Next Page
Loading...
