11
Preparing for Auto-Emptying
Notes:
• If the power cable hangs vertically to the ground, it may be caught by the robot, causing the
dock to be moved or disconnected.
• The dock indicator is on when the dock is powered on, and off when the robot is charging.
• The dock indicator turns red if an error occurs.
• Place the dock on a flat floor away from fire, heat, and water. Avoid narrow spaces or
locations where the robot may be suspended in the air.
• Placing the dock on a soft surface (carpet/mat) may cause the dock to tilt over and cause
problems docking and departing.
• Keep the dock away from direct sunlight or anything that may block the dock location
beacon; otherwise, the robot may fail to return to the dock.
• Do not use the dock without clean water tank, dirty water tank, high-speed maintenance
brush, or water filter.
• Maintain the dock according to the maintenance instructions. Do not clean the dock with a
wet cloth or tissue.
• All docks are subject to water-based tests before leaving the factory. It is normal that a small
amount of water remains in the waterway of the dock.
Installation
1. When auto-emptying for the first time or if the dock has not
emptied for an extended period, empty the robot dustbin
manually and clear the air inlet of any debris to ensure optimum
performance.
2. Remove the plate covering the air inlet in the robot.
Powering On & Charging
Press and hold the button to power on the robot. Wait until
the power light is steady, and then place the robot on the dock to
charge. The robot is equipped with a high-performance lithium-ion
rechargeable battery pack. To maintain battery performance, keep
the robot charged during normal use.
Note: The robot may not be turned on when the battery is low. In this case, connect
the robot to the dock.
*
Images are for illustration purposes only and may not exactly represent the product.
The color of the power
indicator indicates the
battery level.
• White: ≥ 20%
• Red: < 20%
To Next Page
Loading...
Need help?
General