11
D1–1—Take out the dirty tank, pull out the
cover, and take out the filter from the
cover. Remove any trash attached
to the filter using the provided
maintenance brush. If the filter is
dirty, rinse it with cold water and
then shake off the residual water.
D1
Cleaning the Dirty Tank and
Filter
Ŏ Use the maintenance brush carefully to avoid injury.
Ŏ Before you clean the roller, make sure that the
vacuum cleaner is switched off or in upright and
locked position
Notes:
D2–1—
D2–2—
D2–3—
D2–4—
Press the release buttons on both
sides of the cover simultaneously and
lift the cover upwards to detach it.
Clean the smart active drive wheels regularly.
Unplug the charging dock and use a soft
dry cloth to clean the surface and charging
contacts of the charging dock.
Press the buttons on one side of the
roller and pull the roller out from
the side. Remove any dirt attached
to the roller using the provided
maintenance brush, and rinse it with
clean water.
Rinse the detached roller cover with
clean water.
Reinstall the roller and roller cover in
the correct order.
D2
Cleaning the Roller and
Roller Cover
D3
Cleaning the Smart Active
Drive Wheels
D4
Cleaning the Cleaning Head
and Dirty Water Pipe
D5
Cleaning the Charging Dock
Do not wash the cleaning head directly with water.
Do not rinse the charging dock directly with
water.
Note:
Note:
Notes:
Ŏ Use a second filter if necessary.
Ŏ Do not touch the filter with your hands, brushes, or
sharp objects to avoid damage to the filter.
D1–2—Dry all parts thoroughly before
installing them back in place.
1. Switch off the vacuum cleaner and
stabilize the body. Remove the dirty tank,
roller cover, and roller.
2. Clean the roller slot and dirty water pipe
with the provided maintenance brush.
3. Reinstall the roller, roller cover, and dirty
tank in place.
Basic Parameters
Vacuum Cleaner
Dock Charger
Model WD3D1A
Rated Input
25.6V
1A
Battery
21.6 V/4000 mAh (TYP)
Lithium-ion battery
Model MDS06LRR
Rated Input
Voltage
120V~
Rated
Frequency
60Hz
Rated Input
(Hot water
washing mop)
12A
Rated Input
(Charging &
drying)
1.4A
Rated Output
25.6V
1A
Charging
Battery
21.6 V/4000 mAh
(TYP) Lithium-ion
battery
To Next Page
Loading...
