024
Cleaning Rear Filter
Follow these instructions when inspecting and cleaning the
Rollers to ensure optimum performance. Inspection and cleaning
should be performed regularly. Before removing the roller,
remove the accessory from the vacuum to avoid accidental
damage.
5. When dry, reinstall the filter by aligning it with the unlock mark,
slotting it into the vacuum, then turning clockwise to lock it in
place.
1. Hold the brush so that the locking mechanism faces you. Turn
the lock counterclockwise and remove it.
2. After removing the locking mechanism, remove the roller.
Cleaning the Rollers
Cleaning the Motorized Mini-Brush
Note: The Motorized Mini-Brush roller must be removed and cleaned separately. As there
are electrical components and bearings in the Motorized Mini-Brush and Multi-Surface
Brush rollers, do not wash them with water.
Roller Lock
*
Washing the Rear Filter every two months is recommended
Maintenance
To Next Page
Loading...
