Need help?Do you have a question about the Roborock H7 and is the answer not in the manual?
General| Product type | Stick vacuum |
|---|---|
| Dust capacity | - L |
| Product color | Grey, Red |
| Dust container type | Dust bag |
| Removable handheld vacuum | Yes |
| Display type | OLED |
| Cleaning type | Dry |
| Vacuum air filtering | HEPA |
| Dirt separating method | Filtering |
| Number of filter layers | 5 pc(s) |
| Power source | Battery |
| Charging time | 2.5 h |
| Suction power | 160 AW |
| Maximum input power | 480 W |
| Quantity per pack | 1 pc(s) |
| Quantity | 1 |
| Number of dust bags | 2 pc(s) |
| Vacuum brushes included | Dusting brush, Mini motorized brush |
Weight and Dimensions| Depth | 230 mm |
|---|---|
| Width | 111 mm |
| Height | 284 mm |
| Weight | 1461 g |
Slight scratches from transportation are normal and do not indicate a used product.
Lines are molding marks, not cracks; they are normal and do not affect the dust bin's function.
Gray filter is a pre-filter for fine dust; recommended to wash monthly.
This is the rear HEPA filter; recommended to wash monthly for optimal performance.
Press to enter/exit continuous mode; press for 2 seconds to stop the vacuum.
Yes, main switch enables continuous mode; trigger starts/stops the run.
Standard for daily cleaning, ECO for quiet areas, MAX for dirtier areas or higher suction.
Run time varies by mode and tool, ranging from approximately 8 to 45 minutes.
It takes approximately 2.5 hours to charge from 0% to 100%.
Do not vacuum liquids or gooey items; this can cause water damage to the fan.
This indicates a blockage in filters, brush heads, or tube; clear all blockages.
Overcurrent/overheat protection stops the brush if entangled or motor is too hot. Remove debris.
Check for blockages in the air duct, dust bin, filters, extension tube, or brush pipe and clear them.
Check for overheating or entangled debris. Wait for cooling or clean the brush head.
Overcurrent/overheat protection stops the brush due to high resistance. Remove entangled debris.
Check battery level, charge if low. Cool down the machine if it's due to high temperature protection.
Check dust bin, pre-filter, rear filter, extension tube, and brush pipe for any blockages.
Ensure the machine is within the operating temperature range (4-40°C) for charging.
Check the charging stand socket, clean contacts and electrodes, and remove dust from the socket.
If battery is very low, the screen may not turn on. Charge in a cool, dry place.
Empty dust bin weekly, clean filters monthly, and clean brush rollers monthly.
Use tap water only. Detergents and disinfectants may damage the rubber sealing.
No, do not use a dishwasher as high temperatures can cause deformation or damage.
Remove the side cover of the soft roller brush to take out the roller and remove tangled hair.
Washable parts include crevice, dusting, filters, cyclone, dust bin. Non-washable parts have motors/bearings.
Low temperature may prevent restarting. Allow the vacuum to warm up to room temperature.
Low temperature may hinder starting. Leave the vacuum at room temperature for a while before use.
The vacuum may have entered engineering mode. Press main switch to exit or leave idle for 2 minutes.
To Next Page
