placed on the charging dock, but they will loosen slightly and become normal after a period of
use.
72. Q: How to use the magnetic charging station
？
A: There is a magnet on the side of the button of the crevice tool, motorized mini-brush ,flex
tube ,dusting brush .The magnet of these accessories can be adsorbed on the charging station,
and can also be adsorbed on other iron surfaces, such as refrigerators.
73. Q:How to use the child lock?
A: Press the lock button for 5 seconds when Vacuum is in standby or charging to enter the child
lock state. Similarly, long press to turn off the child lock function.
Troubleshooting related
1. Q: The vacuum cleaner shuts down after sucking in
and expelling air a few times. What should I do?
A: Sucking in and expelling air 5 times indicates that the air duct is blocked. Please check
the following: 1) The dust bin may be full or the contents may exceed the MAX line.
Please empty the dust bin. 2) The pre-filter may be blocked. Please remove and clean it.
3) The rear filter may be blocked. Please remove and clean it. 4) The extension tube may
be blocked. Please clean it. 5) The brush pipe may be blocked. Please clean the pipe
inside the brush head. 6) The suction inlet may be completely blocked when vacuuming.
2. Q: The Soft Roller Brush/ Multi-Surface Brush does
not work. What should I do?
A: 1. The Soft Roller Brush and Multi-Surface Brush motors have temperature protection
switches. When the motor temperature is too high, it will automatically shut down. Please
wait for an hour before trying to use it again. If temperature protection occurs frequently,
please remove and clear entangled debris on both sides of the brush head. 2. The
charging contacts are dirty. Please wipe the position shown in the diagram.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
