11
Pull out the main brush caps.
After removing the tangled hair or
dirt at both ends of the main brush,
reinstall it, press on the main brush
cover to lock it in place.
C1-8—
C1-9—
Notes:
• Main brush should be wiped down with a wet cloth and left
to dry away from direct sunlight.
• Do not use corrosive cleaning fluids or disinfectants to
clean the main brush.
100-240V~
20V
1.2A
20V
1.2A
Basic Parameters
Robot
Note: The serial number is on a sticker on the underside of
the robot.
< 6 hoursCharging Time
Q80ULLModel
14.4V/5200mAh (TYP)
lithium-ion battery
Battery
Rated Input
Charging Dock
14.4V/5200mAh (TYP)
lithium-ion battery
Charging Battery
CDZ12RR or CDZ20RR
Model
28WRated Power
Rated Input
Rated Output
50-60HzRated Frequency
*
Clean monthly and replace every 3-6 months.
1. Unscrew the side brush screw.
2. Remove and clean the side brush.
Reinstall the brush and tighten the screw.
C2
Side Brush
*
Clean as required.
*
Clean monthly.
Use a tool, such as a small screwdriver,
to pry out the axle and take out the
wheel.
The omnidirectional wheel bracket cannot be removed.
Note:
C3-1—
Clean the main wheels with a soft, dry cloth.
C3
Omnidirectional Wheel
C4
Main Wheels
Rinse the wheel and the axle with
water to remove any hair and dirt.
Dry and reattach the wheel, pressing
it firmly in place.
C3-2—
C5-5—Allow 24 hours for the filter to dry
thoroughly and reinstall it.
C5-1—Press the latch to remove the unit.
Remove the washable filter then
empty the dustbin.
C5
Dustbin and Water Tank
Combo Unit
*
Clean weekly and replace the filter every 6-12 months
C5-2—Empty the water tank of unused water.
C5-3—Fill the dustbin with clean water and
gently shake it. Then pour out the
dirty water.
C5-4—Rinse the filter repeatedly and tap it to
remove as much dirt as possible.
To prevent blockage, only use clean water without any
cleaning liquid.
Note:
Do not touch the surface of the filter with your hands,
brush, or hard objects to avoid potential damage.
Note:
Purchase an additional filter and alternate if necessary. Note:
C6
Mop Cloth
*
Clean after each use and replace every 3-6 months
Remove the mop cloth from mop cloth
mount. Clean the mop cloth and air-dry it.
A dirty mop will affect the mopping performance. Clean
it before use.
Note:
C7
Robot Sensors
Use a soft, dry cloth to wipe and clean all
sensors, including:
C7-1—Dock Locator
C7-2—Reactive Tech Obstacle Avoidance
Sensor
C7-3—Wall Sensor
C7-4—Cliff Sensors
*
Clean monthly.
*
Clean monthly.
Note: If the robot will be left unused for a long period, turn it
off and charge it at least every three months to avoid battery
damage caused by over-discharge.
Use a soft dry cloth to wipe the charging
contacts on the charging dock and the robot.
Battery
The robot is equipped with a built-in
high-performance lithium-ion rechargeable
battery pack. To maintain battery
performance, keep the robot charged
during normal use.
C8
Charging Contact Areas
To Next Page
Loading...
Need help?
General
