Whisk function : speed between 500 and 1800
rpm.
Mixer function : speed between 2300 and 9600
rpm.
It is advisable to start at a low speed when using
the whisk.
With the self-regulating speed system, once you
have selected a speed, it will remain constant, even
if the consistency of your mixture changes.
WORKING POSITION
• BLADE FUNCTION
For greater control, we
recommend that you
hold the power mixer by
the handle and the
bottom of motor unit.
Furthermore, we recom-
mend that you tilt the
power mixer at a slight
angle to prevent the bell
from touching the bot-
tom of the container.
The power mixer can
equally be rested
against the rim of the
container, but must be
tilted, and the bell must
not touch the bottom of
the container.
7
Always make sure that the bell is sufficiently
immersed to avoid splashing and that the air vents
of the motor unit does not come into contact with
any liquid.
For optimum efficiency, two thirds of the foot should
be immersed in the preparation.
• WHISK FUNCTION
You can also hold the
appliance by the handle
with one hand, leaving
the other hand free
to hold the bowl, if
necessary.
While you process the
preparation, we recom-
mend that you move the
whisks around in the
bowl, in order to ensure
that the mixture is com-
pletely homogeneous.
We strongly advise you
to keep the whisks from
touching the sides of the
bowl. For maximum
efficiency, at least one-
fifth of the whisk length
should be immersed.
We also strongly advise
you to start the proces-
sing at a low speed.
ASSEMBLING /
DISMANTLING
• BLADE FUNCTION
Attaching the tube to the motor unit.
(only for CMP Combi)
- Check that the appliance is not plugged in.
- Align the flat side of the conical part of the
tube with catch into the aluminium casing.
- Insert the whole of the conical part of the tube
into the aluminium casing.
- Turn the tube in the direction of the arrow (see
figure) until it is locked into place moderately tightly.
Removing the tube from the motor unit
(only for CMP Combi)
- Check that the appliance is unplugged.
- Turn the tube in the opposite direction to that used
when attaching it.
- When it will go no further, remove the tube of the
aluminium casing.
CMP ANGLAIS:CMP FRANCAIS 8/04/08 15:25 Page 7
To Next Page
Loading...
