5.4 ACF60-00 WIRING
If any of the original wire as supplied with the unit must be replaced, it must be replaced with thermoplastic
221°F wire, except ground, high temperature and pressure switch wires 392°F or equivalent.
Igniter and flame sensor wire have to be replaced with Robur spare parts. See, SPARE PARTS, page 60.
Label all wires prior to disconnection when servicing the controls. Wiring errors can cause improper
and dangerous operation.
In Figure 20, below, Thermostat THL (Hot water outlet thermostat) is placed only on ACF60-00 HR.
Figure 18 – WIRING DIAGRAM FOR ACF60-00
To Next Page
Loading...
