How to fix oil or liquid leakage from Robuschi Blower?
If you notice oil or liquid leaking from your Robuschi Blower, it could be due to worn gaskets or a worn drive shaft seal. Try replacing the gaskets or replacing the seal to resolve the leakage.
Why Robuschi Robox Evolution ES 65 / 3DV-RVP125-CAR motor does not start up and there is no noise?
If the motor of your Robuschi Blower doesn't start and there's no noise, it could be due to several reasons: * At least two electric connections have been cut off. In this case, check the fuses, terminal boards, and connection cables, and replace them if needed. * One electric connection has been cut off. * Incorrect electric connection. Check the electric system. * Faulty motor. Check the electric motor.
What to do if Robuschi Robox Evolution ES 65 / 3DV-RVP125-CAR motor does not start but humming noise is heard?
If the motor of your Robuschi Blower doesn't start but you hear a humming noise, it could be due to: * At least two electric connections being cut off. Check the fuses, terminal boards, and connection cables, replacing them if necessary. * One electric connection being cut off. * Incorrect electric connection. Check the electric system. * A faulty motor. Check the electric motor.
Why is the inlet pressure different from the rated value in my Robuschi Blower?
If the inlet pressure of your Robuschi Blower is different from the rated value, it could be because the inlet piping is clogged. Inspect the piping and remove any obstructions.
How to fix a Robuschi Robox Evolution ES 65 / 3DV-RVP125-CAR relief valve that does not close?
If the relief valve on your Robuschi Blower does not close, it might be due to a wrong relief valve setting. Try resetting it.
Table detailing operational limits (RPM, pressure, temperature) for different sizes.
Lists prohibited operations and associated risks for the ROBOX DV.
Outlines residual risks and necessary precautions for ROBOX DV operation.
Instructions for safely making electrical connections to the ROBOX DV.
Essential checks to perform before starting up the ROBOX DV.
Step-by-step guide for the initial startup of the ROBOX DV.
Step-by-step guide for performing an oil change on the ROBOX DV.
Instructions for replacing the filter elements in ROBOX DV sizes 2 and 3.
Instructions for replacing the filter elements in ROBOX DV sizes 4 and 5.
Procedures for checking and adjusting the tension of the V-belts.
Steps for replacing the V-belts and pulleys on the ROBOX DV.
Detailed instructions for replacing the motor of the ROBOX DV.
Procedure for replacing the shaft seal in the ROBOX DV blower.
Lists common operating problems and their potential causes for ROBOX DV.
Detailed table linking specific causes to their solutions for ROBOX DV issues.
General| Model | Robox Evolution ES 65 / 3DV-RVP125-CAR |
|---|---|
| Voltage | 400V |
| Frequency | 50 Hz |
| Protection Class | IP55 |
| Insulation Class | F |
| Pressure | 1000 mbar |
| Inlet/Outlet Connection | DN 65 |
| Type | Rotary Lobe Blower |
To Next Page
