ID005 | Revision: E
R3D362
RoHS
R-R-VTB-PSEL
BSMI 限用物質聲明表查詢,請上 https://bsmi.roccat.com/
VOYETRA TURTLE BEACH, INC. | 44 SOUTH BROADWAY, 4TH FLOOR,
WHITE PLAINS, NY 10601, USA
© 2023 Voyetra Turtle Beach, Inc. All rights reserved. Any product names mentioned in this manual may
be trademarks or registered trademarks and are the property of their respective owners. Information
contained herein is subject to change without notice. Voyetra Turtle Beach, Inc shall not be made liable
for any errors that may appear in this manual. This publication or parts of it may not be reproduced
without the express consent of the publisher. ROCCAT® is a Turtle Beach Brand.
Our goods come with guarantees that cannot be excluded under the Australian Consumer Law. You are
entitled to a replacement or refund for a major failure and for compensation for anyother reasonably
foreseeable loss or damage. You are also entitled to have the goods repaired or replaced if the goods fail
to be of acceptable quality and the failure does not amount to a major failure.
本表格依据SJ / T 11364的规定编制。
О：表示该有毒有害物质在该部件所有均质材料中的含量均在GB / T 26572规定的限量要求以下。
Х：表示该有毒有害物质至少在该部件的某一均质材料中的含量超出GB / T 26572规定的限量要求。
有害物质名称及含量标识格式
产品中有害物质名称及含量
部件名称 有害物质
铅(Pb) 汞(Hg) 镉(Cd)六价铬(Cr
+6
)多溴联苯(PBB)
多溴二苯醚(PBDE)
印刷電路板組件
塑膠部件/外殼
金屬部件/螺絲
連接線及組件
Х
О
О
Х
О
О
О
О
О
О
О
О
О
О
О
О
О
О
О
О
О
О
О
О
Hereby, Voyetra Turtle Beach
Corp.
declares that this product is in compliance with the
essential requirements and other relevant provisions of Directive 2014/30/EU.
The full Declaration of Conformity can be requested via following:
Company: Voyetra Turtle Beach, Inc.
Address:
44 South Broadway, 4th Floor, White Plains, NY 10601, USA
E-Mail: support@roccat.com
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference and (2) this device must accept any
interference received, including interference that may cause undesired operation
FCC CAUTION:
GENERAL SAFETY GUIDELINES AND INTENDED USE
1. Do not open or modify the product.
2. Not approved changes or modifications may void the operation
authority and/or warranty.
3. In case of trouble or doubt, contact us immediately.
4. Keep the product away from fire/water/humidity/temperature
extremes.
5. Only use as intended with a compliant PC and connector part.
6. Improper or incorrect use of the product or use of the product for
purposes not recommended by the manufacturer void the liability and/
or warranty.
7. Don‘t look into the light beam on bottom of the mouse.
DRIVERLESS SETUP
To enter config mode: hold down buttons 1, 2, 3 and 8 (default left click, right
click, middle mouse, and DPI) for 3 seconds. The LED will show a sequence of
white, red, green, then blue.
To exit config mode: press buttons 1, 2, 3 and 8 at the same time once.
The LED will show a sequence of blue, green, red then white.
Buttons 6 & 7 (browser forward & browser backward):
Change polling rate. The LED will blink twice in the color of the selected
polling rate:
125Hz – Blue
250Hz – Green
500Hz – Yellow
1000Hz – White (default)
Button 3 (middle mouse button): Swap between 1mm and 2mm lift-
o distance. The LED will blink twice in the color of the selected lift-o
distance:
1mm – Red (default)
2mm – Purple
While holding button 1 (left mouse button), mouse wheel up/down:
Change debounce value. The LED will blink twice in the color of the
selected lift-o distance:
2ms – Orange
5ms – Purple (default)
10ms – Cyan
While holding button 1 (left mouse button), buttons 6 & 7
(browser forward & browser backward):
Change LED brightness (steps of 10%). The LED will immediately change.
While holding button 2 (right mouse button), mouse wheel up/down:
Change LED Color (16 preset colors). The LED will immediately change.
(This will not aect Wave mode).
While holding button 2 (right mouse button), buttons 6 & 7
(browser forward & browser backward):
Change LED mode (choose from Static, Wave, Heartbeat, Breathing, and
Blinking). The LED will immediately change.
Join the community
Become a ROCCAT member and register your product at:
www.roccat.com/support/register-your-product
Please use your product’s serial number
(located on the bottom label)
Service & support
Easy access to
customer support
Authenticity check
Make sure you
own an original
Exclusive deals
Opt-in for special
oers and downloads
如需協助...
我們的支援團隊將會協助您處理任何技術問題。
請傳送電子郵件至 support@roccat.com 或造 訪 我 們 的 網站：
WWW.ROCCAT.COM/SUPPORT
系統需求
Windows® 7 及更高版本 (軟件支持)
USB 2.0 連接埠或更高版本
網路連線 (為了安 裝驅 動程 式)
PURE SEL 技術規格
PixArt PAW3318 8K DPI 光學感應器
200 IPS (5.1m/s) 最大追蹤速度
30g 最大加速度
預設 DPI 段 位：400、800 (預設)、1200、1600、3200
1,000Hz 輪詢率
抬起偵測距離：1mm、2mm 可自訂
機械式鍵軸，生命週期達 20 億次擊鍵數
重 量：49 克
To Previous Page
Loading...
