rock space AC1200 User Manual

2. Hardware Installation
2.1 Hardware Installation
Please connect the router according to the following steps.
1. Connect the Modem to ADSL Filter using RJ11 network cable, LINE port to
LINE port.
2. Connect the ADSL’s LAN port to Router’s WAN port using RJ45 network
cable.
3. Connect your PC to any one of router’s LAN port.
4. Plug the Power Adapter into the router and then into an outlet.
5. Turn on your computer.
6. Check and confirm that the Power & LAN LED on the router are ON.
2.2 Check the Installation
The control LEDs of the router are clearly visible and the status of the network link
can be seen instantly:
1. With the power source on, once the device is connected to the broadband
modem, the Power, LAN, WLAN and WAN port LEDs of the WLAN Router will light
up indicating a normal status.
2. When the WAN Port is connected to Internet successfully, the WAN LED will light
up.

rock space AC1200 Specifications

General

Brand	rock space
Model	AC1200
Category	Wireless Router
Language	English