3 To Call
To dial a number, make sure that your
headset is turned on, then dial the number
from your phone. Your headset will activate
as soon as the number is dialed.
To voice dial a number (not supported on
all phones), press send/end. A tone plays,
which is your signal to speak the command
or number.
Know the facts
Recharge time: About two hours
Talk time: Up to eight hours
Standby time: Up to 300 hours
Phone pairing: Up to eight phones at the same time
LEDs
To... Do this...
End a call Press send/end.
Answer a call Press send/end.
Redial a number Double-press send/end.
Reject a call
Double-press send/end.
Switch a call
between the
headset and
the phone.
Mute a call Double-press send/end.
10-0723
4 Maintaining
Press and hold the
power button and
send/end for about
two seconds.
To... Do this...
Increase
the volume
Decrease
the volume
Swipe upward (toward the ear)
on the touch pad.You will hear a
dierent "beep" for each level
change in volume.
Swipe downward (away from
the ear) on the outside of the
headset.
To...
Enable or disable the indicator
Check the battery level (method 1)
Check the battery level (method 2)
Erase paired device information
Multipoint pairing (pairing the
headset to multiple phones)
Reset
Disconnect from the phone (un-pair)
Do this...
Press the power button and send/end together.
Turn the headset on, then press and release the power button.
Green = Between 1/2 and full charge
Green then red = Between 1 hour talk time remaining
and 1/2 charge
Red = Less than 1 hour talk time remaining.
Turn the headset on. If the indicator ashes red and green,
or if it beeps ever y 300 seconds, the batter y level is low.
Turn the headset o, then press and hold the power button
and send/end together for about two seconds.
Pair each phone with the headset. When you are in a call with one phone
but the other phone rings, press send/end to switch to the second call.
Connect the charger to reset the headset, then user can power on
headset after remove the charger.
Turn the headset o, then use the phone’s Bluetooth menu to
disconnect it. For help with this step, see your cell phone’s user guide.
Green Power On
Green (fast ashing) Pairing State
Red (ashing) Low Battery
RF-EX7
EX7
WITH PURE SPEECH®
Hear and be heard like never before
© 2010 Best Buy Enterprise Services, Inc. Distributed by Best Buy Purchasing, LLC • 7601 Penn Avenue South, Richfield, MN USA 55423-3645
RFEX7 QUICK SETUP GUIDE
FCC Part 15
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference,
and (2) this device must accept any interference
received, including interference that may cause
undesired operation.
FCC ID: EMJTRFEX7
“You are cautioned that changes or modications not
expressly approved by the part responsible for
compliance could void the
user’s authority to operate the equipment”.
Canada IC-RSS210 statement
IC: 4251A-HRFEX7
Operation is subject to the following two conditions:
(1) this device may not cause interference, and
(2) this device must accept any interference, including
interference that may cause undesired operation of
the device.
To Previous Page
Loading...
Need help?
General
