30
My memory card appears in My Computer but
I get errors when writing or reading
• Make sure that the memory card is fully inserted into the
slot.
• Try a different memory card of the same type in the same
slot. If a different memory card works, replace the
original memory card.
• Some cards have a read/write security switch. Make sure
that the security switch is set to Write Enabled.
• Make sure that the amount of data you tried to store
does not exceed the capacity of your memory card.
• Inspect the ends of the memory cards for dirt or material
closing a hole. Clean the contacts with a lint-free cloth
and small amounts of isopropyl alcohol.
• If errors persist, replace the memory card.
Specifications
Specifications are subject to revision or update without
notice.
Hard drive type 3.5“SATA HDD
Dimensions 1.67 × 8.74 × 5.19 in (42.5 × 222 × 132 mm)
D×W×L
Interface to drive SATA
Interface to the computer USB 2.0 / eSATA
Connectors/buttons front • Backup button
• Memory card reader (two slots)
•Two USB ports
Connectors/buttons back • Power button
•DC power jack
• B type USB port
•eSATA port
RF-AHD35_09-0774_MAN_ENG_V3.fm Page 30 Friday, September 25, 2009 6:51 AM
To Next Page
Loading...
Need help?
General
