ENGLISH 11-1204
Troubleshooting
Problem:
Equipment connected to
your Power Manager does
not turn on.
Components have AC power
but still don’t work.
1 Make sure that your Power Manager is plugged into
a working, grounded AC outlet.
2 Check all power connections and make sure that the
power outlet is not switched (and turned o).
NOTE: Test the outlet with a working lamp. Try both the top and
the bottom outlets.
3 Make sure that the Power Manager switch and
connected devices are turned on.
1 Make sure that all power cords are connected
correctly.
2 Make sure that all devices are turned on and
working properly.
NOTE: Try plugging the devices in question directly into the wall.
3 Make sure that the primary device (computer or TV)
is turned on and is not in standby or sleep mode.
Solution:
Safety information
• To ensure the safety of children and to avoid electric shock and damage from a
high-dust environment, slide the plastic outlet cover over outlets that are not in use.
• To protect your phone, fax, or modem from surges, plug the phone line from the wall
outlet into the IN port and phone/fax/modem line(s) into the OUT port(s).
• To protect your cable modem or TV/TV tuner from surges, connect your coax cable
from the wall outlet into the IN coax port, then connect a coax cable from the OUT coax
port to the device.
Legal notices
FCC Statement:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC
Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not
occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the
equipment o and on, the user is encouraged to try to correct the interference by one or more of the following measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and receiver.
— Connect the equipment into an outlet on a circuit dierent from that to which the receiver is connected.
— Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not
cause harmful interference, and (2) this device must accept any interference received, including interference that may cause
undesired operation.
One-year limited warranty
Visit www.rocketfishproducts.com for details.
We’re here for you:
For customer service call 1-800-620-2790
www.rocketfishproducts.com
Distributed by Best Buy Purchasing, LLC
7601 Penn Avenue South, Rich eld, MN 55423-3645 USA
© 2012 BBY Solutions, Inc.
All rights reserved. ROCKETFISH is a trademark of BBY Solutions, Inc.
All other products and brand names are trademarks of their respective owners.
Specications
Outlets: 12
Phone/Fax line protection (RJ11): 1 in / 2 out
Network protection (RJ45): 1 in / 1 out
Coaxial cable protection (F): 2 in / 2 out
Power cord: 8 ft. (2.4m) Soft-Flex™ right-angle plug
Joules rating: 4350
Connected equipment warranty: $500,000
Continuous Duty Electrical Rating: 15A / 125V / 1875W
Maximum Energy Dissipation
and H-N / H-G / N-G values: 4,350J/210,000A
Maximum Spike Current 6,000V/210,000A
and H-N / H-G value /N-G values: (H-N 90,000A) (H-G 30,000A) (N-G 30,000A)
UL Clamping Voltage: UL 1449/ 330V(L-N)400V(L-G,N-G)
Response Time: Less than 1 nanosecond
EMI/RFI Noise Filtration: 150K Hz - 100M Hz, Up to 58dB
To Previous Page
Loading...
Need help?
General
