To Next PageTo Next Page
Need help?Do you have a question about the Rockford Fosgate Prime R250X1 and is the answer not in the manual?
General| Number of Channels | 1 |
|---|---|
| Power Output (RMS @ 4 Ohms) | 250 Watts |
| Speaker Output Connector | Screw Terminals |
| Power Input Connector | Screw Terminals |
| Frequency Response | 20Hz - 250Hz |
| Total Harmonic Distortion (THD) | <1% |
| Input Sensitivity | 150 mV - 4 V |
| Crossover | Low-pass |
| Fuse Rating | 30A |
| Power Output (RMS @ 2 Ohms) | 250 Watts x 1 @ 2-Ohms |
General safety warnings and precautions for installation and use, including potential hazards.
Key precautions to follow before and during installation to prevent injury or damage.
Adjustable filter for controlling frequency range, with Butterworth characteristics.
Allows adjustment of phase angle (0-180°) to synchronize speaker arrival times.
Switches for selecting crossover mode (LP/AP/HP) and input signal alignment.
LEDs indicating power status and protection/thermal shutdown conditions.
Controls for bass frequency boost (Punch EQ) and matching audio source output (Gain).
Optional remote control for adjusting subwoofer output level from the dash.
Details on power, speaker, and RCA input/output connection terminals and their features.
List of necessary tools and components included in the amplifier package.
Guidance on pre-planning layout, wiring, mounting, and general safety rules.
Recommendations for checking vehicle's electrical system capacity and using heavy-duty components.
Step-by-step instructions for connecting power, ground, remote, and signal cables.
Procedure for setting the amplifier's input sensitivity to match the source unit's output.
Setting the crossover point (50-250Hz) for High Pass, All Pass, or Low Pass filtering.
How to use the Punch EQ for bass, mid-bass, or treble boost depending on crossover setting.
Configuring the input switch for 2-channel, 4-channel, or 5-channel input modes.
How to adjust the phase angle between 0° and 180° for optimal sound staging.
Connecting the amplifier using speaker-level signals from factory radios without RCA outputs.
Installation and operation of the optional remote control for subwoofer volume adjustment.
