10
Installation
Rear Speakers for Tour-Pak models.
Step 1 - Rear Speaker Removal
Unscrew the speaker grilles from the rear pods and remove factory
speaker. Disconnect the factory wiring from the speaker terminal
and remove speaker.
Step 2 - Rear Speaker Installation
Connect the speakers by sliding the speaker wire connector over
the speaker terminals
NOTE: The smaller terminal is the positive (+) and the larger
terminal is the negative (-).
Step 3 - Speaker Installation
Insert the new Rockford speaker and grille assembly onto the
speaker opening on the backside of the fairing. Use the included
screws to securely mount the speakers
Connect the speakers by sliding the speaker wire connector over
the speaker terminals
NOTE: The smaller terminal is the positive (+) and the larger
terminal is the negative (-).
To Next Page
Loading...
Need help?
General
