9
Installation
NOTE: There are two screw lengths included in the hardware pack.
For this fairing application, use the longer screws on the top two
mounting holes of the speaker.
Connect the speakers by sliding the speaker wire connectors over
the speaker terminals
NOTE: The smaller terminal is the positive (+) and the larger
terminal is the negative (-).
Front Speakers for Road Glide
®
and Road Glide
Ultra
®
models.
Step 1 - Fairing Removal
Leaving the windshield in place, remove the six inner fairing
screws.
After the screws are removed, use your socket or ratcheting wrench
to unbolt the turn signal brackets.
NOTE: Some turn signal brackets stay attached and some can be
completely removed. This varies depending on aftermarket and
factory accessory styles
Pull the fairing toward the front of the bike and up to release it from
the fairing mounts. Unplug headlight harness and set fairing aside.
Step 2 - Speaker Removal
After the fairing is removed, unplug the wires from both speaker
terminals. Remove the screws that secure the factory speaker from
the fairing.
To Next Page
Loading...
Need help?
General
