How to fix Rocks OK-03.4130 Lawn Mower when auto mode won't start and charging station beeps?
If your Rocks Lawn Mower is not able to start in auto mode and the charging station is beeping, it could be due to a cut virtual wire. Check the virtual wire light on the charging station to ensure the wire is properly connected (light should be colorless). You may need to connect the virtual wire with wire connectors.
What should I do if my Rocks Lawn Mower stops and beeps because it ran out of wire?
If your Rocks Lawn Mower stops working and beeps, it might be because the mower ran out of wire. The virtual wire signal could be too weak. Try setting the virtual wire current to an appropriate value or resetting the virtual wire where the signal is weak.
What to do if Rocks Lawn Mower stops working and beeps due to lift or pressure sensor?
If your Rocks Lawn Mower stops working and beeps, it could be due to the lift or pressure sensor being activated. To resolve this, take the mower to level ground and restart it. Also, make sure to remove any objects that might be obstructing the mower.
Why Rocks Lawn Mower auto mode won't start, charging station beeps, and signal light is off?
If your Rocks Lawn Mower is not able to start in auto mode and the charging station is beeping with the signal light off, the charging station might not be getting power. Check the power connection and ensure the charger is properly connected to both the power supply and the charging station. Also, make sure the main power is on. It could also indicate bad communication between the charging station and the mower.
How to troubleshoot Rocks OK-03.4130 Lawn Mower stopping and beeping due to virtual wire signal failure?
If your Rocks Lawn Mower stops working and beeps, the virtual wire might be failing to send signals. Test the wire sensors in the area where the mower lost signal. If the signal is too weak, reset the virtual wire.
Why is my Rocks OK-03.4130 Lawn Mower so noisy?
If your Rocks Lawn Mower is very noisy, several factors could be responsible. These include a damaged cutting blade (replace it), cutting blade flooded by residues (remove the residues), starting the mower too close to obstacles (start in a new place), damaged motor (repair or replace by service station), or grass that is too high (increase cutting height or use a normal lawn mower).
What to do if my Rocks Lawn Mower gets stuck and won't move?
If your Rocks Lawn Mower gets stuck and does not move, it could be due to extremely overgrown or very wet grass. Cut the grass to an appropriate height. Alternatively, the terrain might need landscaping repairs. Fill in any holes and cover or exclude any exposed roots to smooth the terrain.
What to do if Rocks OK-03.4130 stops and beeps because it is over tilted?
If your Rocks Lawn Mower stops working and beeps, it could be that the robot is over tilted. Turn off the mower, move it to level ground, and then restart it.
Why Rocks OK-03.4130 does not complete the edge?
If your Rocks Lawn Mower does not complete the edge, there might be an obstacle along the path. Watch the full operation of follow virtual wire walking and confirm no obstacle is present.
What to do if Rocks Lawn Mower does not detect the charging station contacts?
If your Rocks Lawn Mower does not detect the charging station contacts, the ground before the charging station might not be flat. Reset the charging station in a flat place.
General| Brand | Rocks |
|---|---|
| Model | OK-03.4130 |
| Category | Lawn Mower |
| Language | English |
To Next Page