EasyManuals Logo

Rockwell Automation PanelView Plus 1000 User Manual

Rockwell Automation PanelView Plus 1000
248 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #205 background imageLoading...
Page #205 background image
Publication 2711P-UM001I-EN-P - December 2008 205
Upgrade Firmware Chapter 8
Ignore this error. It will be corrected during the upgrade. Press
OK to acknowledge error and wait for terminal to reset.
14. On touch or touch-screen terminals, you must calibrate the
touch screen by selecting pointers in all four corners of the
screen and pressing the middle of the screen when prompted.
Ignore the following message if it appears. It means FactoryTalk
View ME is being installed. Do not touch the two buttons that
appear with the message.
Machine edition may be corrupted. Do you want to download
firmware?
Communication settings are cleared when the terminal is
upgraded. If Ethernet communications is used, reconfigure the
Ethernet communication settings using the values recorded
when preparing the terminal.
15. Replace the .MER files that you backed up before starting the
upgrade or download the new .MER files to the terminal.
16. Load the .MER file and run the project.
TIP
If a USB mouse is available, you can acknowledge the
error by selecting OK.
TIP
You can configure your application to start automatically
on power cycle under Startup Options.

Table of Contents

Other manuals for Rockwell Automation PanelView Plus 1000

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Rockwell Automation PanelView Plus 1000 and is the answer not in the manual?

Rockwell Automation PanelView Plus 1000 Specifications

General IconGeneral
BrandRockwell Automation
ModelPanelView Plus 1000
CategoryTouch terminals
LanguageEnglish

Related product manuals