10
800W JIG SAW EN
your power tool. Never use water or chemical cleaners
to clean your power tool. Wipe clean with a dry cloth.
Always store your power tool in a dry place. Keep the
motor ventilation slots clean. Keep all working controls
free of dust. Occasionally you may see sparks through
the ventilation slots. This is normal and will not damage
your power tool.
If the supply cord is damaged, it must be replaced by
the manufacturer, its service agent or similarly qualied
persons in order to avoid a hazard.
TROUBLESHOOTING
1. If your tool will not operate, check the fuse and the
power at the mains plug.
2. If the tool is not cutting properly, check the blade and
the support roller, replace blade if worn. Also check the
cutting angle. The blade must be at exactly 90°to the
base plate for normal use. (See Fig. N)
3. If a fault can not be found return the tool to an
authorized dealer for repair.
To Next Page
Loading...
