What to do if my Rocky Mountain Powerplay Bicycle shows 'Low Voltage Protection'?
If your Rocky Mountain Bicycle displays a 'Low Voltage Protection' error, this indicates that the battery voltage is low. The solution is to recharge the battery.
What to do if my Rocky Mountain Bicycle is showing 'Over Temperature Protection'?
If your Rocky Mountain Bicycle is showing an 'Over Temperature Protection' message, it means the drive has overheated. Allow the drive to cool down.
What causes a Torque Fault on a Rocky Mountain Bicycle and how to fix it?
A 'Torque Fault' on your Rocky Mountain Bicycle is caused by a torque sensor error. To resolve this, clean or clear the Torque Sensor Arm and then calibrate the Torque Sensor.
What to do if my Rocky Mountain Powerplay Bicycle shows 'Communication Fault Lost Frame Job'?
If your Rocky Mountain Bicycle displays 'Communication Fault Lost Frame Job', there is a communication error between the iWoc and the Drive. Power the iWoc off and then on. For further assistance, it's recommended to see a dealer.
General| Suspension | Full Suspension |
|---|---|
| Wheel Size | 29" |
| Category | E-Mountain Bike |
| Rear Shock | Fox Float X2 Factory |
| Drivetrain | Shimano XT |
| Brakes | Shimano XT |
| Tires | Maxxis Assegai 2.5" WT |
| Handlebar | Race Face |
| Stem | Race Face |
| Frame Material | Carbon |
| Wheelset | Race Face |
To Next Page
