9
STARTING
for a few seconds enabling the systems to fill in the pipes and to reach the required pressure. If this
and wait, with a tap openned until the red led is off. Once released the button and closed the tap the
unit stops the pump at its max. pressure.
FUNCTIONING
The starting operation archived, the unit is programmed to perform all the pump control
operations automatically. When particular operational breakdowns occur, such as water failure,
up, at the same time a stop signal is sent to the pump to prevent damages caused by its working in
the absence of water. Rectification of the failures that have caused the blockage, allows the system
MAINTENANCE
If specialist personel must be brought in for extrordinary service or repairs during the warranty
period and thereafter please contact a service provider recommended by us or contact the
manufacturer directly. Despite the care taken during the manufacture and tests procedures if the tool
goes out of order, please have the tool repaired by the authorised “RODEX” service agents.
Overhauls maintenanace work, cleaning, as well as the elimination of any malfunctions must only
be undertaken after turning off the machine. All protective and safety equipment must be reinstalled
immediately upon completion of ay repair or maintenance work. We recommend
That the unit should be emptied when not using for a long period of time and there is a risk of
frozen when the remperature is too low. THE UNIT SHOULD NEVER BE OPERATED DRY.
To Next Page
Loading...